Safety First: 8 Steps to Installing Winter Tire Chains. http://www.tranbc.ca
CVSE provides general instructions on how to install winter tires. For more information, go to this link: http://www.th.gov.bc.ca/SeasonalDriving/winter/documents/Brochure_InstallationOfTireChains.pdf
Step 1 - Lay the chains out on the ground with the traction part of the crosslink facing the ground. Ensure the chains are free of twists and tangles.
Step 2 - Place the chain over the tire with the fastener on the outside and the traction part facing up, away from the tire. Ensure the side chains and fastener hooks are not under the tire. Place
excess loose crosslinks under the tire. Hook the inside fastener as tight as possible, followed by the outside fastener pulling as tight as possible.
Step 3 - Drive forwards or backwards over the chain until the hooks are at axle height, about halfway up the tire.
Step 4 - Hook the inner chain first, as tight as possible, leaving just enough room to hook the outer fastener.
Step 5 - First, hook the middle fastener tightly.
Step 6 - Next, hook up the inside rail as tight as possible.
Step 7 - Hook up the outside rail as tight as possible.
Step 8 - If chains are equipped with tightening device (d-cam tightener), tighten now. If not, use bungee cords to remove slack.
For further information on tips for winter driving and safety tips check out Shift Into Winter: http://www.th.gov.bc.ca/SeasonalDriving/index.html
Special thanks to our CVSE staff Steve Haywood, Bruce Calbick and Cole Delisle for creating the video.
Commercial Vehicle Safety & Enforcement : http://www.th.gov.bc.ca/cvse/index.htm
Tags: Safety First: 8 Steps to Installing Winter Tire Chains, winter driving, CVSE, Winter Tire installation